How to control a water pump from your phone
Short answer. Have an electrician fit a smart switch on the pump's circuit, or a smart relay that drives a motor contactor for bigger pumps, and run it from an app or dashboard. For a transfer pump, insist on three protections: a stop level from a sensor in the tank it draws from, dry-run detection from the pump's power, and a switch that turns itself off if it loses contact. Without them, a pump started from your phone can run dry while you're away.

Three ways people do it
- A GSM relay you call or text. Works without the internet, but needs a SIM card with credit, usually can't tell you whether the pump is really running, and knows nothing about the tank.
- A Wi-Fi smart switch with an app. Cheap and quick. The app shows on or off, but not how much water is left, so the person pressing the button is the only protection.
- Pump control linked to tank sensors. The pump starts and stops at levels you choose, stops itself when something is wrong, and still answers your phone.
Check the rating before you switch a motor
Many smart switches are rated for simple loads such as heaters and lights (often marked AC-1). A pump motor draws several times its running current for a moment as it starts. Unless the switch is rated for motor loads at your pump's size, it should switch the coil of a motor-rated contactor (AC-3) instead, with a breaker and overload protection upstream. As a rough guide this matters above about 1.5 kW. It's an electrician's job, in your panel.
The protections a remote pump needs
- A stop level. A sensor in the tank the pump draws from stops it before the intake reaches air.
- Dry-run detection. A pump that loses its water draws less power. A switch that measures power can stop it within a minute or two. See how to stop a pump running dry.
- A safety timer on the switch. If it hears nothing from the system for a while, it turns the pump off by itself. Ours waits ten minutes.
- Off after a power cut. When the power returns, the pump waits for the system, or a person, to decide.
- A limit on starts. A rest between runs and a cap on starts per hour protect the motor.
How fast should it answer?
On a working installation, our pump switch confirms a start or stop in 3 to 8 seconds. Anything under ten seconds feels immediate. If a system takes a minute, people press the button twice.
Who gets the button
Give staff a code that can start and stop the pumps, and keep changes to levels and schedules behind a separate admin code. When someone switches a pump by hand, automatic control should step back for a while instead of fighting them.
Kanari fits the switch, the sensors and all of the protections above, with our own electrician. See every feature.
Want this done for you?
Sensors in your tanks, pumps that run themselves, alerts when something needs a person.
Book a visit or call